✈️Proposed FAA AD for Piaggio Model P-180 Airplanes Compliance
The FAA proposes to supersede Airworthiness Directive (AD) 2023-25-03, which applies to certain Piaggio Aviation S.p.A. (Piaggio) Model P-180 airplanes. AD 2023-25-03 requires a one-time detailed inspection of the horizontal stabilizer (HS) central box for corrosion; an assessment of the corrosion level; and depending on the determination, repetitive detailed inspections of the HS central box for corrosion and the internal composite structure for surface cracks, distortion, and damage; and repair or replacement of the HS assembly. Repair or replacement of the HS assembly is terminating action for the repetitive inspections. Since the FAA issued AD 2023-25-03, it was determined that AD 2023-25-03 imposed an unintended restriction that is not in the mandatory continuing airworthiness information (MCAI). This proposed AD would retain certain actions of AD-2023-25-03 and would remove the unintended restriction. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️FAA Proposes Revocation of Federal Airways in Alaska
This action proposes to revoke Colored Federal Airway Green 6 (G-6) and Alaskan Very High Frequency Omnidirectional Range (VOR) Federal Airways V-459 and V-496 in Alaska. The identifier V-459 is also used for a VOR Federal Airway in California. This action is proposing to revoke the Alaskan V-459, not the V-459 in California. The FAA is proposing this action due to the pending decommissioning of the St. Marys, AK, Nondirectional Radio Beacon (NDB) and the Aniak, AK, NDB.
Learn More🛡️Updated Safety Standards for Play Yards Effective April 2025
In August 2012, the U.S. Consumer Product Safety Commission (CPSC or Commission) published a consumer product safety standard for play yards pursuant to section 104 of the Consumer Product Safety Improvement Act of 2008 (CPSIA). The Commission's mandatory standard incorporates by reference ASTM F406, Standard Consumer Safety Specification for Non-Full-Size Baby Cribs/Play Yards, with modifications that exclude sections of ASTM F406 that apply to non- full-size (NFS) cribs exclusively. The CPSIA sets forth a process for updating mandatory standards for durable infant or toddler products that are based on a voluntary standard, when a voluntary standards organization revises the standard. In September 2024, ASTM published a revised voluntary standard, and this direct final rule updates the mandatory standard for play yards to incorporate by reference the 2024 version of ASTM F406.
Learn More✈️Proposed FAA AD Impacts Costs for GE Engine Compliance
The FAA is revising a notice of proposed rulemaking (NPRM) that applied to all General Electric Company (GE) Model CF34-10E2A1, CF34-10E6, CF34-10E6A1, CF34-10E7, and CF34-10E7-B engines with certain part-numbered high-pressure turbine (HPT) shroud/low pressure turbine (LPT) nozzle assemblies installed. This action revises the NPRM by adding Model CF34-10E5 and CF34-10E5A1 engines to the applicability. The FAA is proposing this airworthiness directive (AD) to address the unsafe condition on these products. Since these actions would impose an additional burden over those in the NPRM the agency is requesting comments on this SNPRM.
Learn More✈️FAA Revokes Kwajalein Island Airspace Classifications
This action revokes the Class D and Class E airspace in the Republic of the Marshall Islands (RMI). RMI is an independent nation, and the FAA does not have regulatory authority to establish or amend domestic airspace pursuant to Title 14 Code of Federal Regulations (14 CFR) part 71 over RMI's land or territorial waters.
Learn More✈️Class E Airspace Amendment for Kenansville, NC Effective April 2025
This action amends Class E airspace extending upward from 700 feet above the surface for Kenansville, NC, by adding airspace for ECU Health Duplin Heliport. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations at this airport.
Learn More🛩️FAA Proposes Airspace Change
This action proposes to revoke Jet Route J-606 and establish United States Area Navigation Route (RNAV) Q-182 in Alaska. The FAA is proposing this action due to the pending decommissioning of the Chinook, AK, Nondirectional Radio Beacon (NDB).
Learn More✈️FAA Proposes New Airworthiness Directive Affecting Airbus Aircraft
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus SAS Model A319-111, -112, -113, -114, -115, -131, - 132, -133 airplanes. This proposed AD was prompted by a widespread fatigue damage (WFD) scenario review for a certification project that indicated several cracks found around the potable water and wastewater service panels were WFD instead of typical fatigue. This proposed AD would require modification of the potable water and wastewater service panels, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Modification of Airspace at Bozeman Yellowstone Airport
This action proposes to modify the Class D surface area airspace, Class E airspace area designated as surface area, Class E airspace areas designated as an extension to a Class D or Class E surface area, and the Class E airspace area extending upward from 700 feet above the surface of the earth at Bozeman Yellowstone International Airport, Bozeman, MT. These actions would support the safety and management of visual flight rules (VFR) and instrument flight rules (IFR) operations at the airport.
Learn More🌎Proposed EPA Regulations on Ethylene Oxide Emissions Standards
The Environmental Protection Agency (EPA) is proposing to establish a new area source category to address chemical manufacturing process units (CMPUs) using ethylene oxide (EtO). The EPA is proposing to list EtO in table 1 to the National Emission Standards for Hazardous Air Pollutants (NESHAP) for Chemical Manufacturing Area Sources (referred to as the CMAS NESHAP in this document) and to add EtO- specific requirements to the CMAS NESHAP. The EPA is also proposing to add a fenceline monitoring program for EtO. In addition, the EPA is proposing new requirements for pressure vessels and pressure relief devices (PRDs). This proposal also presents the results of the EPA's technology review of the CMAS NESHAP as required under the Clean Air Act (CAA). As part of this technology review, the EPA is proposing to add new leak detection and repair (LDAR) requirements to the CMAS NESHAP for equipment leaks in organic HAP service and heat exchange systems. The EPA is also proposing performance testing once every 5 years and to add provisions for electronic reporting. We estimate that the proposed amendments to the CMAS NESHAP, excluding the proposed EtO emission standards, would reduce hazardous air pollutant (HAP) emissions from emission sources by approximately 158 tons per year (tpy). Additionally, the proposed EtO emission standards are expected to reduce EtO emissions by approximately 4.6 tpy.
Learn More