✈️FAA Seeks Comments on Suspected Unapproved Parts Information Collection
In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The information collected on the FAA Form 8120-11 is reported voluntarily by manufacturers, repair stations, aircraft owner/ operators, air carriers, and the general public who wish to report the discovery of, and potential use or possession of aircraft suspected unapproved parts to the FAA for review. The report information is collected and evaluated by the FAA, Aviation Safety Hotline Program Office, and used to determine if an unapproved part investigation is warranted.
Learn More✈️New FAA Airworthiness Directive for Airbus SAS Airplanes
The FAA is superseding Airworthiness Directive (AD) 2015-02- 14, which applied to all Airbus SAS Model A318 series airplanes; A319- 111, -112, -113, -114, -115, -131, -132, and -133 airplanes; A320-211, -212, -214, -231, -232, and -233 airplanes; and A321-111, -112, -131, - 211, -212, -213, -231, and -232 airplanes. AD 2015-02-14 required repetitive inspections for cracking, damage, correct installation, and correct adjustment of the main landing gear (MLG) door hinge and actuator fittings on the keel beam, corrective actions if necessary, and revision of the existing maintenance or inspection program, as applicable. Since the FAA issued AD 2015-02-14, a new design of the MLG door keel beam hinge and actuator fitting was developed. This AD continues to require the actions specified in AD 2015-02-14, adds an optional terminating action, and revises the applicability, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚁Proposed Airworthiness Directives for Airbus Helicopters by FAA
The FAA proposes to supersede Airworthiness Directive (AD) 2019-19-13, which applies to certain Airbus Helicopters Model EC225LP helicopters. AD 2019-19-13 requires determining the total hours time- in-service (TIS) of the free wheel shafts of certain main rotor gearboxes (MGBs), replacing the MGB or right-hand side (RH) free wheel shaft, installing placard(s), and revising the Rotorcraft Flight Manual (RFM) for the helicopter. Since the FAA issued AD 2019-19-13, an additional part-numbered MGB has been identified to have the same unsafe condition and the FAA determined that additional changes are necessary. This proposed AD would require the actions of AD 2019-19-13 and, expand the applicability by adding the additional part-numbered MGB, change the requirement to determine the total hours TIS of a certain free wheel shaft, require repetitive replacement of the MGB or the RH free wheel shaft, change the requirements for who can replace parts, and expand the parts installation limitation conditions. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directives for Airbus A350
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A350-941 and -1041 airplanes. This AD was prompted by a determination that new or more restrictive airworthiness limitations are necessary. This AD requires revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚀FAA Announces Airspace Closures for SpaceX Starship Operations
The FAA is announcing the availability of the Tiered Environmental Assessment (Tiered EA) and Finding of No Significant Impact/Record of Decision (FONSI/ROD) for Updates to Airspace Closures for the Flight 9 Mission Profile of the SpaceX Starship-Super Heavy Vehicle at the SpaceX Boca Chica Launch Site in Cameron County, Texas. (Tiered EA FONSI/ROD).
Learn More✈️Proposed Airworthiness Directive for Airbus Canada Aircraft
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus Canada Limited Partnership Model BD-500-1A10 and BD- 500-1A11 airplanes. This proposed AD was prompted by reports that the interface pin of the secondary load path in the upper gimbal of the horizontal stabilizer trim actuator (HSTA) was incorrectly installed. This proposed AD would require a detailed visual inspection of the interface pin of the HSTA to determine if the interface pin is incorrectly installed, and applicable on-condition actions as specified in a Transport Canada AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️FAA Issues New Airworthiness Directive for Airbus A350 Compliance
The FAA proposes to adopt a new airworthiness directive (AD) for all Airbus SAS Model A350-941 and A350-1041 airplanes. This proposed AD was prompted by reports of mechanical noises originating from the nose landing gear (NLG) shock absorber during ground maneuvers. This proposed AD would require repetitive inspections (i.e., steering checks) of the NLG shock absorber and applicable on-condition actions and limit the installation of affected parts under certain conditions. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️Revocation of VOR Airway & Amendment of Navigation Routes in Alaska
This action revokes Alaskan Very High Frequency Omnidirectional Range (VOR) Federal Airway V-414 and amends United States Area Navigation (RNAV) Routes T-248 and T-250 in Alaska. These actions are due to the decommissioning of the Nondirectional Radio Beacon (NDB) portion of the Gambell NDB/distance measuring equipment (DME) in Alaska.
Learn More✈️FAA Amends VOR Federal Airways
This action amends domestic Very High Frequency Omnidirectional Range (VOR) Federal Airways V-1, V-29, V-38, V-139, and V-286 in the eastern United States. The FAA is taking this action due to the planned decommissioning of the Salisbury, MD (SBY), VOR/Tactical Air Navigation (VORTAC) and the Snow Hill, MD (SWL), VORTAC. This action is in support of the FAA's VOR Minimum Operational Network (MON) Program.
Learn More✈️Class E Airspace Amendment in Payson, AZ
This action amends the Class E airspace at Payson, AZ. This action is the result of an airspace review conducted due to the decommissioning of the Payson non directional beacon (NDB). This action also updates the name and geographic coordinates of the airport to coincide with the FAA's aeronautical database. This action brings the airspace into compliance with FAA orders and supports instrument flight rule (IFR) procedures and operations.
Learn More