✈️FAA Withdraws Proposed Rule on Boeing Airworthiness Directives
The FAA is withdrawing a notice of proposed rulemaking (NPRM) that proposed to supersede Airworthiness Directive (AD) 2023-08-04, which applies to certain The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. The NPRM was prompted by reports of a loss of water pressure during flight and water leaks that affected multiple pieces of electronic equipment, and by the discovery that some clamshell couplings did not have the required safety strap. The NPRM would have required inspecting all door 1 and door 3 lavatory and galley potable water systems for missing or incorrectly installed clamshell couplings, inspecting all clamshell couplings for the presence and correct installation of safety straps at door 1 and door 3 lavatories and galleys with a potable water system, and performing applicable on- condition actions. The NPRM would have also prohibited the installation of affected parts at inspection locations and removed Model 787-10 airplanes from the applicability. Since issuance of the NPRM, the FAA has determined that the identified service information may not adequately address the unsafe condition on one of the galleys, and Model 787-10 airplanes should be included in the applicability. Accordingly, the NPRM is withdrawn.
Learn More✈️FAA Issues Airworthiness Directive for Bombardier Airplanes
The FAA is superseding Airworthiness Directive (AD) 2021-10- 02, which applied to all Bombardier, Inc., Model BD-700-1A10 and BD- 700-1A11 airplanes. AD 2021-10-02 required repetitive general visual inspections of the left- and right-hand elevator torque tube bearings for any sand, dust, or corrosion; repetitive functional tests of the elevator control system; and replacement of the elevator torque tube bearings if necessary. This AD continues to require certain actions in AD 2021-10-02 and requires revising the existing maintenance or inspection program, as applicable, to incorporate a new airworthiness limitation. This AD was prompted by a determination that a new airworthiness limitation is necessary. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directive for CFM Engines by FAA
The FAA is adopting a new airworthiness directive (AD) for certain CFM International, S.A. (CFM) Model LEAP-1A and LEAP-1C engines. This AD was prompted by an investigation of an in-flight shut down event that revealed the aft arm of the high-pressure turbine (HPT) rotor interstage seal had failed. This AD requires removal from service and replacement of the HPT rotor interstage seal for LEAP-1A engines. Since the HPT rotor interstage seal part number is interchangeable between LEAP-1A and LEAP-1C engines, this AD also prohibits installation of these affected parts onto any LEAP-1A or LEAP-1C engine. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Special Conditions for Gulfstream GVII-G400 Aircraft
This action proposes special conditions for the Gulfstream Aerospace Corporation (Gulfstream) Model GVII-G400 airplane. This airplane will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport-category airplanes. This design feature is a high-speed protection system. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Learn More🛩️New FAA Airworthiness Directive for Britten-Norman Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Britten-Norman Aerospace Ltd. Model BN-2, BN-2A, BN-2A-2, BN- 2A-3, BN-2A-6, BN-2A-8, BN-2A-9, BN-2A-20, BN-2A-21, BN-2A-26, BN-2A- 27, BN-2B-20, BN-2B-21, BN-2B-26, BN-2B-27, BN-2T, BN2T-4R, and BN2T-4S airplanes; and certain Model BN2A MK. III, BN2A MK. III-2, and BN2A MK. III-3 airplanes. This AD was prompted by the determination that, in order to ensure the continued structural integrity of certain landing gear and associated components, it is necessary to require removal of these components from service prior to exceeding established fatigue lives. This AD requires determining the number of landings on affected main landing gears (MLGs), nose landing gears (NLGs), and associated components; removing from service any part that has reached or exceeded the established fatigue life and installing a replacement part; and prohibiting the installation of any affected part unless the number of landings for that part is below the established fatigue life. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Airworthiness Directive for DAHER Model TBM 700 Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain DAHER AEROSPACE (DAHER) Model TBM 700 airplanes. This AD was prompted by reports of wear of the inner flap actuator drive nut. This AD requires cleaning and lubricating the internal actuator rods, measuring the play between the drive nuts and the internal actuator rods, and if any play is found, replacing the drive nuts. This AD also allows replacing the drive nuts with certain other design drive nuts as terminating action for the requirements. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Airworthiness Directive on Boeing 767
The FAA is superseding Airworthiness Directive (AD) 2019-14- 13, which applies to all The Boeing Company Model 767-200, -300, -300F, and -400ER series airplanes. AD 2019-14-13 required identifying the part number, and the serial number if applicable, of the Captain's and First Officer's seats, and performing applicable on-condition actions for affected seats. AD 2019-14-13 also required a one-time detailed inspection and repetitive checks of the horizontal movement system (HMS) of the Captain's and First Officer's seats, and applicable on- condition actions. AD 2019-14-13 also provided an optional terminating action for the repetitive actions for certain seats. This AD was prompted by reports of uncommanded fore and aft movement of the Captain's and First Officer's seats. This AD retains the actions in AD 2019-14-13 and adds an inspection of previously omitted part numbers. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚁FAA Issues Airworthiness Directive for Airbus Helicopters
The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Model AS332L, AS332L1, AS 365 N3, SA-365C1, SA- 365C2, SA-365N, and SA-365N1 helicopters. This AD was prompted by a report that certain rescue hoist cable assemblies may be equipped with a defective ball end. This AD requires inspecting certain rescue hoist cable assemblies and, depending on the results, replacing the rescue hoist cable assembly. This AD also allows installing certain rescue hoist cable assemblies and certain rescue hoists provided its requirements are met. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚁New Airworthiness Directive for Leonardo Helicopters by FAA
The FAA is adopting a new airworthiness directive (AD) for all Leonardo S.p.a. Model A109E, A109K2, A109S, AB412, AB412 EP, AB139, and AW139 helicopters. This AD was prompted by a report that certain rescue hoist cable assemblies may be equipped with a defective ball end. This AD requires inspecting certain rescue hoist cable assemblies and, depending on the results, replacing the rescue hoist cable assembly. This AD also allows installing certain rescue hoist cable assemblies and certain rescue hoists provided its requirements are met. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Boeing Airworthiness Directive
The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. This AD was prompted by a report of operators receiving No. 1 flight compartment windows that may not meet type design requirements for withstanding a bird impact. This AD requires replacing affected No. 1 flight compartment windows and prohibits the installation of affected windows. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More