✈️New Airworthiness Directive Impacts Airbus Canada Airlines
The FAA is adopting a new airworthiness directive (AD) for all Airbus Canada Limited Partnership Model BD-500-1A10 and BD-500-1A11 airplanes. This AD was prompted by a design review that discovered software protection logic for potential large leaks from the engine bleed duct inside the engine core compartments was partially impaired. This AD requires revising the existing airplane flight manual (AFM) to incorporate the procedures for the flightcrew to manually isolate the opposite functional engine in the event of an engine bleed duct large leak condition, as specified in a Transport Canada AD, which is incorporated by reference (IBR). The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Proposed AD for Safran Helicopter Engines Raises Compliance Costs
The FAA proposes to adopt a new airworthiness directive (AD) for all Safran Helicopter Engines, S.A. (Safran) Model ARRIUS 2F and ARRIUS 2R engines. This proposed AD was prompted by a manufacturer investigation that revealed certain high-pressure (HP) turbine blades may contain non-compliant porosity rates due to a change in the manufacturing process. This proposed AD would require replacement of affected HP turbine blades, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Airworthiness Directive for Textron Aviation Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Textron Aviation, Inc., Model 560 and 560XL airplanes. This proposed AD was prompted by reports of mis-wired fire extinguishing bottles. This proposed AD would require an engine fire extinguisher system functional test, an inspection of the fire extinguisher bottle cartridge wire numbers and yellow ID sleeves for proper identification and legibility, and applicable corrective actions. This proposed AD would also require revising the existing inspection program to incorporate new airworthiness limitations for repetitive inspections of the engine fire extinguisher wiring and, as applicable, auxiliary power unit (APU) fire extinguisher wiring. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directives for Airbus Canada Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Airbus Canada Limited Partnership Model BD-500-1A10 and BD-500- 1A11 airplanes. This AD was prompted by a report that the nose radome lightning diverter strips on certain aircraft were painted in production; paint on the diverter strips can compromise the nose radome lightning protection. This AD requires inspecting for paint on the diverter strips on the nose radome, and replacing the nose radome if necessary, as specified in a Transport Canada AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Airworthiness Directive for Boeing 787 Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. This proposed AD was prompted by reports that very high frequency (VHF) radio frequencies transfer between the active and standby windows of the tuning control panel (TCP) without flightcrew input. The uncommanded frequency changes could result in missed communications between the flightcrew and Air Traffic Control. This proposed AD would require updating the TCP operational software (OPS) and performing a software configuration check. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️FAA Proposes New Airworthiness Directive for Airbus Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus Canada Limited Partnership Model BD-500-1A10 and BD- 500-1A11 airplanes. This proposed AD was prompted by an investigation that showed a change in the feed-through connector O-ring material at a certain frame increased the electrical bonding resistance due to the current torque specification being inadequate. This proposed AD would require electrical bonding tests between the feed-through connectors and the forward side of the bulkhead at a certain frame, and the installation of two electrical bonding plates of connectors, as applicable, as specified in a Transport Canada AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️FAA Issues Airworthiness Directive for MHI RJ Aviation Aircraft
The FAA is adopting a new airworthiness directive (AD) for all MHI RJ Aviation ULC Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes. This AD was prompted by the discovery of ten ultrasonic inspections associated with airworthiness limitations (AWL) tasks and structural deviation inspection requirements (SDIR) tasks potentially not detecting cracks. This AD requires repetitive ultrasonic inspections of certain structural areas for cracking, and prohibits use of the previous revisions of certain procedures and mandates the use of the revised procedures when performing the inspections required by the associated AWL and SDIR tasks, as specified in a Transport Canada AD, which is incorporated by reference (IBR). This AD also requires repair of cracking. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directive for Boeing 757 Aircraft Inspections
The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 757-200, -200CB, and -200PF series airplanes. This AD was prompted by a report indicating an operator has found cracks on three Model 757-200PF airplanes at the main deck cargo door cutout forward and aft hinge attachment holes. This AD requires a maintenance record check for repairs at the forward and aft hinge areas of the main deck cargo door cutout; repetitive open-hole high frequency eddy current (HFEC) inspections for cracks in the unrepaired areas of the bear strap, skin, doubler, and upper sill chord at the main deck cargo door forward and aft hinge attachment holes; and applicable corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Airworthiness Directive for DAHER Model TBM 700 Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain DAHER AEROSPACE (DAHER) Model TBM 700 airplanes. This AD was prompted by reports of wear of the inner flap actuator drive nut. This AD requires cleaning and lubricating the internal actuator rods, measuring the play between the drive nuts and the internal actuator rods, and if any play is found, replacing the drive nuts. This AD also allows replacing the drive nuts with certain other design drive nuts as terminating action for the requirements. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Airworthiness Directive for Embraer Aircraft by FAA
The FAA proposes to supersede Airworthiness Directive (AD) 2006-20-08, which applies to all Embraer S.A. Model EMB-145, -145ER, - 145MR, -145LR, -145XR, -145MP, and -145EP airplanes. AD 2006-20-08 requires repetitive inspections to detect cracking or failure of the rod ends and fittings of the aileron power control actuator (PCA) and corrective actions if necessary, and provides an optional terminating action. Since the FAA issued AD 2006-20-08, it has been determined that there was an error in identifying a maintenance task number. This proposed AD would continue to require the actions in AD 2006-20-08 and corrects an error in a task number, as specified in an Ag[ecirc]ncia Nacional de Avia[ccedil][atilde]o Civil (ANAC) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Learn More