✈️Proposed Special Conditions for Gulfstream GVII-G400 Aircraft
This action proposes special conditions for the Gulfstream Aerospace Corporation (Gulfstream) Model GVII-G400 airplane. This airplane will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport-category airplanes. This design feature is a high-speed protection system. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Learn More✈️FAA Withdraws Proposed Rule on Boeing Airworthiness Directives
The FAA is withdrawing a notice of proposed rulemaking (NPRM) that proposed to supersede Airworthiness Directive (AD) 2023-08-04, which applies to certain The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. The NPRM was prompted by reports of a loss of water pressure during flight and water leaks that affected multiple pieces of electronic equipment, and by the discovery that some clamshell couplings did not have the required safety strap. The NPRM would have required inspecting all door 1 and door 3 lavatory and galley potable water systems for missing or incorrectly installed clamshell couplings, inspecting all clamshell couplings for the presence and correct installation of safety straps at door 1 and door 3 lavatories and galleys with a potable water system, and performing applicable on- condition actions. The NPRM would have also prohibited the installation of affected parts at inspection locations and removed Model 787-10 airplanes from the applicability. Since issuance of the NPRM, the FAA has determined that the identified service information may not adequately address the unsafe condition on one of the galleys, and Model 787-10 airplanes should be included in the applicability. Accordingly, the NPRM is withdrawn.
Learn More✈️New Airworthiness Directive for CFM Engines by FAA
The FAA is adopting a new airworthiness directive (AD) for certain CFM International, S.A. (CFM) Model LEAP-1A and LEAP-1C engines. This AD was prompted by an investigation of an in-flight shut down event that revealed the aft arm of the high-pressure turbine (HPT) rotor interstage seal had failed. This AD requires removal from service and replacement of the HPT rotor interstage seal for LEAP-1A engines. Since the HPT rotor interstage seal part number is interchangeable between LEAP-1A and LEAP-1C engines, this AD also prohibits installation of these affected parts onto any LEAP-1A or LEAP-1C engine. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🛩️New FAA Airworthiness Directive for Britten-Norman Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Britten-Norman Aerospace Ltd. Model BN-2, BN-2A, BN-2A-2, BN- 2A-3, BN-2A-6, BN-2A-8, BN-2A-9, BN-2A-20, BN-2A-21, BN-2A-26, BN-2A- 27, BN-2B-20, BN-2B-21, BN-2B-26, BN-2B-27, BN-2T, BN2T-4R, and BN2T-4S airplanes; and certain Model BN2A MK. III, BN2A MK. III-2, and BN2A MK. III-3 airplanes. This AD was prompted by the determination that, in order to ensure the continued structural integrity of certain landing gear and associated components, it is necessary to require removal of these components from service prior to exceeding established fatigue lives. This AD requires determining the number of landings on affected main landing gears (MLGs), nose landing gears (NLGs), and associated components; removing from service any part that has reached or exceeded the established fatigue life and installing a replacement part; and prohibiting the installation of any affected part unless the number of landings for that part is below the established fatigue life. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Amendment of VOR Federal Airways and Establishment of RNAV Routes
This action amends Very High Frequency Omnidirectional Range (VOR) Federal Airways V-9, V-78, V-341, and V-430, and Canadian Area Navigation (RNAV) Route T-765; and establishes United States (U.S.) RNAV Route T-490. The FAA is taking this action due to the planned decommissioning of the VOR portion of the Iron Mountain, MI (IMT), VOR/ Distance Measuring Equipment (VOR/DME) navigational aid (NAVAID). The Iron Mountain VOR is being decommissioned in support of the FAA's VOR Minimum Operational Network (MON) program.
Learn More✈️FAA Issues Airworthiness Directive for Embraer Airplanes
The FAA is adopting a new airworthiness directive (AD) for all Embraer S.A. Model EMB-135ER, -135KE, -135KL, and -135LR airplanes; and Model EMB-145, -145EP, -145ER, -145LR, -145MP, -145MR, and -145XR airplanes. This AD was prompted by a structural assessment that indicated certain central fuselage longitudinal splices are subjected to fatigue damage on multiple sites due to loose fasteners, which may reduce the structural residual strength below the required levels. This AD requires performing repetitive inspections of certain upper central fuselage longitudinal splices and reporting the inspection results, as specified in an Ag[ecirc]ncia Nacional de Avia[ccedil][atilde]o Civil (ANAC) AD, which is incorporated by reference. This AD also requires performing corrective actions if necessary. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Establishment and Amendment of RNAV Routes in Eastern U.S.
This action establishes United States Area Navigation (RNAV) Route T-553 and amends RNAV Routes T-356, T-358, and T-479 in the eastern United States. This action supports FAA Next Generation Air Transportation System (NextGen) efforts to provide a modern RNAV route structure to improve the safety and efficiency of the National Airspace System (NAS).
Learn More✈️FAA Final Rule on Standard Instrument Approach Procedures
This rule amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide for the safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Learn More✈️FAA Airworthiness Directive for Rolls-Royce Engines Effective 2025
The FAA is adopting a new airworthiness directive (AD) for certain Rolls-Royce Deutschland Ltd & Co KG (RRD) Model Trent XWB-97 engines. This AD was prompted by a report of damage to the main fuel hose assembly of the fuel manifold, which resulted an in-flight shut down. This AD requires a one-time set of visual and dimensional inspections of the main fuel hose assembly of the fuel manifold to confirm softness, compliance, and lack of resistance, and for shrinkage, cracks, chafing, dents, kinks, necking, and degradation of the hose braid wire; and, if necessary, replacement of the main fuel hose assembly of the fuel manifold, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Memorandum on Returning to Merit-Based Hiring Practices
The memorandum emphasizes the importance of safety in aviation by ordering a return to non-discriminatory, merit-based hiring within the FAA. It addresses previous issues related to diversity initiatives that may compromise safety standards, requiring a review of personnel qualifications to ensure excellence in air traffic management and passenger safety.
Learn More