✈️FAA Airworthiness Directive for Boeing
The FAA is superseding Airworthiness Directive (AD) 2021-09- 06, which applied to all The Boeing Company Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes. AD 2021-09-06 required repetitive inspections for cracking of the left- and right-hand outboard chords of certain frame fittings and failsafe straps at a certain station around eight fasteners, and repair if any cracking is found. This AD was prompted by additional reports of cracking in the area and a subsequent determination that additional inspections are needed to address the unsafe condition. This AD requires repetitive detailed and ultrasonic inspections for cracking of the left- and right-hand sides of certain frame fittings and failsafe straps, and repair if any cracking is found. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New FAA Airworthiness Directives Impact Boeing 777 Maintenance Costs
The FAA is superseding Airworthiness Directive (AD) 2012-07- 06, which applied to certain The Boeing Company Model 777-200, -200LR, -300, -300ER, and 777F series airplanes. AD 2012-07-06 required revising the maintenance program to update inspection requirements to detect fatigue cracking of principal structural elements (PSEs). This AD was prompted by new revisions to the airworthiness limitations of the maintenance planning document and damage tolerance rating check form document. This AD requires revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Proposes Airworthiness Directive for Boeing 757 Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 757 airplanes. This proposed AD was prompted by reports of precoolers that failed due to a wear-out condition, combined with latently failed overheat detection thermal switches. This proposed AD would require an inspection for heat damage on the engine strut structure, repetitive tests of the thermal switch temperature and ground wires, replacement of the precooler on Model 757-300 airplanes, and applicable on-condition actions. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️FAA Proposes Airworthiness Directive for Boeing 757-200 Inspections
The FAA proposes to supersede Airworthiness Directive (AD) 2018-26-03, which applies to all The Boeing Company Model 757-200 series airplanes. AD 2018-26-03 requires, for the Captain's and First Officer's seats, repetitive horizontal actuator identifications, repetitive checks of the horizontal movement system (HMS), a detailed inspection of the HMS, as applicable, and applicable on-condition actions. AD 2018-26-03 also requires a general visual inspection to determine the seat part numbers of the Captain's and First Officer's seats, a cable adjustment check on seats with certain seat part numbers, and applicable on-condition actions. Since the FAA issued AD 2018-26-03, the FAA has determined that additional seats are affected by the unsafe condition. This proposed AD would retain the actions required by AD 2018-26-03 and add an inspection for previously omitted part numbers. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️FAA Proposes Airworthiness Directive for Boeing 777 Models
The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 777-200LR Series and 777-300ER Series airplanes. This proposed AD was prompted by reports of chafing and arcing damage on the light emitting diode (LED) sidewall wire bundles. This proposed AD would require a general visual inspection (GVI) of the sidewall light for chafing damage and applicable on- condition actions. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️Airworthiness Directive for Boeing 777 Aircraft Requires Compliance
The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 777-200, -200LR, -300, -300ER, and 777F series airplanes. This AD was prompted by a report indicating that an airplane experienced a glideslope (G/S) beam anomaly during an instrument landing system (ILS) approach, which resulted in a higher- than-expected descent rate during the final segment of an ILS approach. The flightcrew might follow misleading flight director (F/D) guidance after disconnecting the autopilot, without reference to the other available information and flight deck indications. This AD requires installing new autopilot flight director computer (AFDC) operational program software (OPS) and doing a software configuration check. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New FAA Airworthiness Directive for Boeing 787 Aircraft Compliance
The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. This AD was prompted by possible horizontal stabilizer pivot pin lockring, outer pivot pin, and outboard spacer misalignment at final assembly. This AD requires inspection of the left-side and right-side horizontal stabilizer pivot pin assemblies for misalignment and incorrect gapping, and applicable on-condition actions. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Issues Correction for Boeing 737 Airworthiness Directive
The FAA is correcting an airworthiness directive (AD) that was published in the Federal Register. That AD applies to all The Boeing Company Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes. As published, the service information referenced in certain paragraphs of the regulatory text is incorrect, and the dates specified in the "System Airworthiness Limitation No. 3--Fan Blade Out Conditions" text and "System Airworthiness Limitation No. 4--Engine Nacelle Maintenance Errors" text of figure 1 to paragraph (j) of the regulatory text are incorrect. This document corrects those errors. In all other respects, the original document remains the same.
Learn More✈️New Airworthiness Directive for Boeing 777
The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 777-200, -200LR, -300, -300ER, and 777F series airplanes. This AD was prompted by a report of a 5-inch crack on the upper wing skin at a certain wing station of the right wing. This AD requires repetitive inspections for cracking of the upper wing skin common to certain fasteners and applicable on-condition actions. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directive for Boeing 737-800
The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 737-800 series airplanes. This AD was prompted by a determination that the compliance time for the initial ultrasonic inspection required by AD 2019-11-06 is insufficient for certain airplanes. This AD requires reducing the compliance time for the ultrasonic inspection of the skin under the drag link assembly. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More