🛩️Kinston NC Class E Airspace Amendment by FAA
This action amends Class E airspace extending upward from 700 feet above the surface for Kinston, NC, by adding airspace for Lenoir Memorial Hospital Heliport, Kinston, NC. This action also updates the coordinates for Kinston Regional Jetport at Stallings Field, Kinston, NC. Controlled airspace is necessary for the safety and management of instrument flight rules (IFR) operations at this airport.
Learn More✈️Airworthiness Directive on Boeing 767
The FAA is superseding Airworthiness Directive (AD) 2019-14- 13, which applies to all The Boeing Company Model 767-200, -300, -300F, and -400ER series airplanes. AD 2019-14-13 required identifying the part number, and the serial number if applicable, of the Captain's and First Officer's seats, and performing applicable on-condition actions for affected seats. AD 2019-14-13 also required a one-time detailed inspection and repetitive checks of the horizontal movement system (HMS) of the Captain's and First Officer's seats, and applicable on- condition actions. AD 2019-14-13 also provided an optional terminating action for the repetitive actions for certain seats. This AD was prompted by reports of uncommanded fore and aft movement of the Captain's and First Officer's seats. This AD retains the actions in AD 2019-14-13 and adds an inspection of previously omitted part numbers. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚁FAA Issues Airworthiness Directive for Airbus Helicopters
The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Model AS332L, AS332L1, AS 365 N3, SA-365C1, SA- 365C2, SA-365N, and SA-365N1 helicopters. This AD was prompted by a report that certain rescue hoist cable assemblies may be equipped with a defective ball end. This AD requires inspecting certain rescue hoist cable assemblies and, depending on the results, replacing the rescue hoist cable assembly. This AD also allows installing certain rescue hoist cable assemblies and certain rescue hoists provided its requirements are met. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directive for Airbus SAS Airplanes by FAA
The FAA is superseding Airworthiness Directive (AD) 2022-11- 01, which applied to certain Airbus SAS Model A300 series airplanes; Model A300 B4-600, B4-600R, and F4-600R series airplanes; and Model A300 C4-605R Variant F airplanes (collectively called Model A300-600 series airplanes). AD 2022-11-01 required a detailed inspection (DET) of the main landing gear (MLG) support rib 5 lower flange, a fluorescent penetrant inspection (FPI) around the spot facing of certain fastener holes if necessary, and applicable corrective actions. This AD was prompted by the determination that additional airplanes are affected by the unsafe condition. This AD continues to require the actions in AD 2022-11-01 and adds airplanes to the applicability, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🛩️New FAA Airworthiness Directive for Britten-Norman Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Britten-Norman Aerospace Ltd. Model BN-2, BN-2A, BN-2A-2, BN- 2A-3, BN-2A-6, BN-2A-8, BN-2A-9, BN-2A-20, BN-2A-21, BN-2A-26, BN-2A- 27, BN-2B-20, BN-2B-21, BN-2B-26, BN-2B-27, BN-2T, BN2T-4R, and BN2T-4S airplanes; and certain Model BN2A MK. III, BN2A MK. III-2, and BN2A MK. III-3 airplanes. This AD was prompted by the determination that, in order to ensure the continued structural integrity of certain landing gear and associated components, it is necessary to require removal of these components from service prior to exceeding established fatigue lives. This AD requires determining the number of landings on affected main landing gears (MLGs), nose landing gears (NLGs), and associated components; removing from service any part that has reached or exceeded the established fatigue life and installing a replacement part; and prohibiting the installation of any affected part unless the number of landings for that part is below the established fatigue life. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Proposes Amendment to Class E Airspace in Marysville, OH
This action proposes to amend the Class E airspace at Marysville, OH. The FAA is proposing this action as the result of an airspace review conducted due to the decommissioning of the Marysville nondirectional beacon (NDB). This action will bring the airspace into compliance with FAA orders and support instrument flight rule (IFR) procedures and operations.
Learn More✈️FAA Withdraws Proposed Rule on Boeing Airworthiness Directives
The FAA is withdrawing a notice of proposed rulemaking (NPRM) that proposed to supersede Airworthiness Directive (AD) 2023-08-04, which applies to certain The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. The NPRM was prompted by reports of a loss of water pressure during flight and water leaks that affected multiple pieces of electronic equipment, and by the discovery that some clamshell couplings did not have the required safety strap. The NPRM would have required inspecting all door 1 and door 3 lavatory and galley potable water systems for missing or incorrectly installed clamshell couplings, inspecting all clamshell couplings for the presence and correct installation of safety straps at door 1 and door 3 lavatories and galleys with a potable water system, and performing applicable on- condition actions. The NPRM would have also prohibited the installation of affected parts at inspection locations and removed Model 787-10 airplanes from the applicability. Since issuance of the NPRM, the FAA has determined that the identified service information may not adequately address the unsafe condition on one of the galleys, and Model 787-10 airplanes should be included in the applicability. Accordingly, the NPRM is withdrawn.
Learn More✈️Proposed Special Conditions for Gulfstream GVII-G400 Aircraft
This action proposes special conditions for the Gulfstream Aerospace Corporation (Gulfstream) Model GVII-G400 airplane. This airplane will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport-category airplanes. This design feature is a high-speed protection system. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Learn More✈️FAA Final Rule on Standard Instrument Approach Procedures
This rule amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide for the safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Learn More✈️FAA Final Rule on Standard Instrument Approach Procedures
This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPS) and associated Takeoff Minimums and Obstacle Departure procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Learn More