🚁Proposed Airworthiness Directive for Leonardo Helicopters by FAA
The FAA proposes to adopt a new airworthiness directive (AD) for certain Leonardo S.p.a. Model A109E, A109S, and AW109SP helicopters. This proposed AD was prompted by reports of incorrect installation of the motor (MTR) cables and the bonding braids connected to the engine fire extinguisher bottles. This proposed AD would require inspecting the cables and bonding braids installation and, depending on the results, accomplishing corrective action, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️New FAA Airworthiness Directive for Airbus SAS Oxygen Generators
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A300 B4-601, B4-603, B4-620, B4-622, B4-605R, B4-622R, C4-605R Variant F, F4-605R, and F4-622R airplanes; Model A310 series airplanes; Model A318, A319, A320, and A321 series airplanes; Model A330-200, -200 Freighter, and -300 series airplanes; Model A330-841 and -941 airplanes; and Model A340-211, -212, -213, -311, -312, -313, -541, and -642 airplanes. This AD was prompted by chemical oxygen generators that failed to activate in service and during maintenance activities. This AD requires replacing affected oxygen generators and prohibits the installation of affected parts, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directive for Airbus Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A319-111, -112, -113, -114, -115, -131, -132, and -133 airplanes; Model A320-211, -212, -214, -216, -231, -232, and - 233 airplanes; and Model A321-111, -112, -131, -211, -212, -213, -231, and -232 airplanes. This AD was prompted by a full-scale fatigue test that found cracks on the main landing gear (MLG) bay rear skin panel at the stringer run-out at Frame 46 and Stringer 32 on the left-hand and right-hand sides. This AD requires repetitive special detailed inspections (SDIs) of the affected area for cracking and applicable corrective actions, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Airworthiness Directive for Bombardier Aircraft Compliance
The FAA proposes to adopt a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-700-1A10 and BD-700-1A11 airplanes. This proposed AD was prompted by a determination that new or more restrictive airworthiness limitations are necessary. This proposed AD would require revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️FAA Issues Airworthiness Directive for Bombardier Airplanes
The FAA is superseding Airworthiness Directive (AD) 2021-10- 02, which applied to all Bombardier, Inc., Model BD-700-1A10 and BD- 700-1A11 airplanes. AD 2021-10-02 required repetitive general visual inspections of the left- and right-hand elevator torque tube bearings for any sand, dust, or corrosion; repetitive functional tests of the elevator control system; and replacement of the elevator torque tube bearings if necessary. This AD continues to require certain actions in AD 2021-10-02 and requires revising the existing maintenance or inspection program, as applicable, to incorporate a new airworthiness limitation. This AD was prompted by a determination that a new airworthiness limitation is necessary. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directive for CFM Engines by FAA
The FAA is adopting a new airworthiness directive (AD) for certain CFM International, S.A. (CFM) Model LEAP-1A and LEAP-1C engines. This AD was prompted by an investigation of an in-flight shut down event that revealed the aft arm of the high-pressure turbine (HPT) rotor interstage seal had failed. This AD requires removal from service and replacement of the HPT rotor interstage seal for LEAP-1A engines. Since the HPT rotor interstage seal part number is interchangeable between LEAP-1A and LEAP-1C engines, this AD also prohibits installation of these affected parts onto any LEAP-1A or LEAP-1C engine. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Amendment of VOR Federal Airways and Establishment of RNAV Routes
This action amends Very High Frequency Omnidirectional Range (VOR) Federal Airways V-9, V-78, V-341, and V-430, and Canadian Area Navigation (RNAV) Route T-765; and establishes United States (U.S.) RNAV Route T-490. The FAA is taking this action due to the planned decommissioning of the VOR portion of the Iron Mountain, MI (IMT), VOR/ Distance Measuring Equipment (VOR/DME) navigational aid (NAVAID). The Iron Mountain VOR is being decommissioned in support of the FAA's VOR Minimum Operational Network (MON) program.
Learn More✈️FAA Issues New Airworthiness Directive for Airbus SAS Airplanes
The FAA is superseding Airworthiness Directive (AD) 2022-16- 06, which applied to certain Airbus SAS Model A330-200, A330-200 Freighter, A330-300, and A330-900 series airplanes; and all Model A340- 200 and A340-300 series airplanes. AD 2022-16-06 required modifying the trimmable horizontal stabilizer actuator (THSA) installation, implementing the electrical load sensing device (ELSD) wiring provisions, and installing and activating the ELSD. This AD was prompted by tests that demonstrated that when the upper secondary load path (SLP) of the THSA is engaged, the THSA might not stall, with consequently no indication of SLP engagement, and by the recent determination that the required actions of AD 2022-16-06 cannot be accomplished on certain airplanes. This AD continues to require the actions in AD 2022-16-06 with revised procedures, and also requires additional actions for certain airplanes, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚁New Airworthiness Directive for Leonardo Helicopters by FAA
The FAA is adopting a new airworthiness directive (AD) for all Leonardo S.p.a. Model A109E, A109K2, A109S, AB412, AB412 EP, AB139, and AW139 helicopters. This AD was prompted by a report that certain rescue hoist cable assemblies may be equipped with a defective ball end. This AD requires inspecting certain rescue hoist cable assemblies and, depending on the results, replacing the rescue hoist cable assembly. This AD also allows installing certain rescue hoist cable assemblies and certain rescue hoists provided its requirements are met. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Boeing Airworthiness Directive
The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. This AD was prompted by a report of operators receiving No. 1 flight compartment windows that may not meet type design requirements for withstanding a bird impact. This AD requires replacing affected No. 1 flight compartment windows and prohibits the installation of affected windows. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More