✈️FAA Airworthiness Directive for Embraer Airplanes
The FAA is superseding Airworthiness Directive (AD) 2020-12- 12, which applied to all Embraer S.A. Model ERJ 170 airplanes and Model ERJ 190-100 STD, -100 LR, -100 ECJ, -100 IGW, -200 STD, -200 LR, and - 200 IGW airplanes. AD 2020-12-12 required repetitive detailed inspections for cracking of the engine inboard and outboard engine pylon lower link lugs, and repair if necessary. This AD continues to require the actions in AD 2020-12-12 with certain reduced compliance times. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directive for GE Aircraft Engines
The FAA is adopting a new airworthiness directive (AD) for certain General Electric Company (GE) Model CF34-10E2A1, CF34-10E6, CF34-10E6A1, CF34-10E7, CF34-10E7-B, CF34-10E5, and CF34-10E5A1 engines. This AD was prompted by a report of cracks found in the high- pressure turbine (HPT) front rotating air seal. This AD requires performing repetitive fluorescent penetrant inspections (FPIs) to detect indications or linear indications (any indication which is four times longer than the width of that same indication) in the HPT front rotating air seal and, if necessary, replacing the HPT front rotating air seal or HPT rotor disk with parts eligible for installation as applicable. This AD also includes an optional terminating action to the repetitive FPIs. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directive for Airbus A350 Requires Critical Inspections
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A350-941 and -1041 airplanes. This AD was prompted by reports of deep spot faces on rib 9 at the lower flange bolting with the lower spar. This AD requires a special detailed inspection for discrepancies of certain pylon bolts, and applicable corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA's Amendments to Standard Instrument Approach Procedures
This rule amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide for the safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Learn More🚁FAA Airworthiness Directive for Airbus Helicopters Safety Compliance
The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Deutschland GmbH (AHD) Model MBB-BK 117 D-3 helicopters. This AD was prompted by a report of over-torqued swashplate bolts on helicopters in service and in production. This AD requires removal of certain swashplate bolts from service and replacement with new (never previously installed on a helicopter) bolts, a one-time inspection for damage on the threads of the bearing ring and control ring of the swashplate and, depending on the results of the inspection, corrective actions. This AD also prohibits the installation of certain swashplates on any helicopter unless certain requirements are met. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Airworthiness Directive for Goodrich Cabin Attendant Seats
The FAA proposes to adopt a new airworthiness directive (AD) for Goodrich cabin attendant seats installed on Airbus SAS Model A330- 200 series, A330-200 Freighter series, A330-300 series, A330-841, A330- 941, A340-200 series, A340-300 series, A340-541, and A340-642 airplanes. This proposed AD was prompted by a report that track attachments used on certain part-numbered seats are non-compliant. This proposed AD would require replacing all seat track attachments and hardware and re-identifying the seat with a new part number. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️FAA Airworthiness Directive for Airbus A350
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A350-941 and -1041 airplanes. This AD was prompted by a report of loss of control of an outboard aileron surface due to hydraulic fluid contaminating an electronic card of the flight control remote module (FCRM). This AD requires replacing any affected elevator FCRM and prohibits installing aileron or spoiler FCRMs in place of elevator or rudder FCRMs. This AD also limits the installation of FCRMs under certain conditions. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directive for Dassault Falcon 7X Aircraft
The FAA is adopting a new airworthiness directive (AD) for all Dassault Aviation Model Falcon 7X airplanes. This AD was prompted by hydraulic leakage from the spoiler power control unit (SPPCU) in service. Relevant investigations determined that, following certain failures, the spoiler electrical control unit (SPECU) can deliver an untimely and permanent activation command to the SPPCU standby electrical pump, which can possibly result in overheating and significant hydraulic leakage of the unit. This AD requires replacing the affected SPECUs and prohibits the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚁New Airworthiness Directive for Airbus Helicopters by FAA
The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Model AS-365N2, AS 365 N3, EC 155B, EC155B1, SA- 365N, and SA-365N1 helicopters. This AD was prompted by reports of loss of tightening torque between the upper ball bearing end and the main rotor (MR) servo-control. This AD requires inspecting the tightening torque and, depending on the results, taking corrective action. This AD also requires reporting information. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directive for Airbus A350
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A350-941 and -1041 airplanes. This AD was prompted by a design review that identified a potential thrust asymmetry condition during derated takeoff operations under certain conditions. This AD requires revising the existing airplane flight manual (AFM) to provide the flightcrew with procedures for derated takeoff limitations. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More