🚁New FAA Airworthiness Directive for Leonardo S.p.A. Helicopters
The FAA is adopting a new airworthiness directive (AD) for all Leonardo S.p.A. Model A119 and AW119 MKII helicopters. This AD was prompted by a report of an electrical failure of the starter-generator, due to a rupture of the drive shaft, which resulted in a partial loss of battery power. This AD requires installing a battery discharge detector and revising the existing Rotorcraft Flight Manual (RFM) for the helicopter. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚁FAA Issues Airworthiness Directive for Leonardo Helicopters
The FAA is adopting a new airworthiness directive (AD) for certain Leonardo S.p.A. Model A109E, A109S, and AW109SP helicopters. This AD was prompted by reports of incorrect installation of the motor (MTR) cables and the bonding braids connected to the engine fire extinguisher bottles. This AD requires inspecting the cables and bonding braids installation and, depending on the results, accomplishing corrective action, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚂Notice of Petition for Waiver of Railway Safety Regulations
This document provides the public notice that the Association of American Railroads (AAR) petitioned FRA for relief from certain regulations concerning track inspections.
Learn More🚀Federal Oversight on Commercial Launch Safety Regulations
This document clarifies that, in instances where launch or reentry activities are conducted from an FAA-licensed commercial site located on land that is owned by a Federal site that the commercial site uses pursuant to an agreement with the Federal site, and the Federal site provides ground safety services and oversight, the vehicle operator may be able to demonstrate an equivalent level of safety to the FAA's ground safety requirements.
Learn More🚁FAA Proposes New Airworthiness Directive for Airbus Helicopters
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus Helicopters Deutschland GmbH (AHD) Model MBB-BK 117 D-3 helicopters. This proposed AD was prompted by reports of momentary direct current (DC) power interruption in flight of both essential busses. This proposed AD would require revising the existing rotorcraft flight manual (RFM) for your helicopter, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More🚆FRA Notice on Railroad Signal System Modification Application
This document provides the public notice that Florida Gulf & Atlantic Railroad (FGA) petitioned FRA seeking approval to discontinue or modify a signal system. FRA is reissuing this notice because of an incorrect docket number given in the previous notice.
Learn More🚁FAA Proposes Airworthiness Directive for Airbus Helicopters
The FAA proposes to adopt a new airworthiness directive (AD) for all Airbus Helicopters Model EC 130 B4 and EC 130 T2 helicopters. This proposed AD was prompted by a report of heavy damage on the fenestron due to the loss of the tail rotor (TR) blade, which broke at the TR hub tension-torsion bar (tension-torsion bar). This proposed AD would require inspecting the tension-torsion bar and, depending on the inspection results, taking corrective actions. This proposed AD would also prohibit performing maintenance using certain maintenance manuals. These proposed actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directive for Boeing Airplanes Addresses Elevator Safety
The FAA is adopting a new airworthiness directive (AD) for all The Boeing Company Model DC-9-81 (MD-81), DC-9-82 (MD-82), DC-9-83 (MD- 83), DC 9-87 (MD-87), and MD-88 airplanes, and Model DC-9-10, DC-9-20, DC-9-30, DC-9-40, and DC-9-50 series airplanes. This AD was prompted by the discovery of jammed elevators during takeoff. This AD requires revising the "Certificate Limitations" section of the existing airplane flight manual (AFM) to include a procedure to confirm elevator surfaces are not jammed in the trailing edge down (TED) position. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New FAA Regulations on Standard Instrument Procedures for Airports
This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPS) and associated Takeoff Minimums and Obstacle Departure procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Learn More🚁New Airworthiness Directive for Airbus Helicopters Announced
The FAA is superseding Airworthiness Directive (AD) 2021-09-14 which applied to certain Airbus Helicopters (Airbus) Model SA330J helicopters. AD 2021-09-14 required repetitively inspecting for a gap between the main gearbox (MGB) oil cooling fan assembly (fan) rotor blade and the upper section of the guide vane bearing housing, installing improved MGB fan rotor shaft bearings, and repetitively inspecting the improved MGB fan rotor shaft bearings. Since the FAA issued AD 2021-09-14, Airbus has developed modifications to the components of the MGB fan bearing assembly and issued new material regarding these modifications. This AD retains the actions required by AD 2021-09-14 and also requires installing the improved MGB fan rotor bearing assembly, which constitutes terminating action for the repetitive inspections. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More