✈️FAA Airworthiness Directive for Boeing Aircraft
The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 767-200, -300, and -400ER series airplanes. This AD was prompted by a report of multiple engine indicating and crew alerting system messages during potable water servicing after the water leaked onto the electronics equipment cooling air filter. This AD requires installation of hoseducts around the left-side section 43 potable water supply hoses and connections, a potable water system leakage test, and applicable corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Proposed FAA AD Impacts Costs for GE Engine Compliance
The FAA is revising a notice of proposed rulemaking (NPRM) that applied to all General Electric Company (GE) Model CF34-10E2A1, CF34-10E6, CF34-10E6A1, CF34-10E7, and CF34-10E7-B engines with certain part-numbered high-pressure turbine (HPT) shroud/low pressure turbine (LPT) nozzle assemblies installed. This action revises the NPRM by adding Model CF34-10E5 and CF34-10E5A1 engines to the applicability. The FAA is proposing this airworthiness directive (AD) to address the unsafe condition on these products. Since these actions would impose an additional burden over those in the NPRM the agency is requesting comments on this SNPRM.
Learn More✈️Airworthiness Directive for CFM LEAP-1B Engines
The FAA is adopting a new airworthiness directive (AD) for certain CFM International, S.A. (CFM) Model LEAP-1B engines. This AD was prompted by a report of a quality escape involving certain high- pressure compressor (HPC) stage 2 seals manufactured without detailed finish machining, which could result in deeper rubs and mechanical damage to the seal teeth of the stage 3-4 compressor rotor blisk (stage 3-4 blisk) of the mating compressor rotor during initial operation. This AD requires a visual inspection of the HPC stage 2 seal, a visual inspection of the forward arm seal teeth of the stage 3-4 blisk, an eddy current inspection (ECI) of the forward arm seal teeth of the stage 3-4 blisk, and replacement of the HPC stage 2 seal and the stage 3-4 blisk, if necessary. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More