✈️Proposed Airworthiness Directive for Dassault Aviation Falcon 2000EX
The FAA proposes to adopt a new airworthiness directive (AD) for certain Dassault Aviation Model FALCON 2000EX airplanes. This proposed AD was prompted by reports of the incorrect installation of the very high frequency omnidirectional range and localizer (VOR/LOC) antenna coupler. This proposed AD would require implementing an operational limitation for Category (CAT) II and CAT III approaches, inspecting the VOR/LOC antenna coupler, and reinstalling the VOR/LOC antenna coupler if necessary, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Learn More⚡New Integrated System Rate Order
The Administrator of the Southwestern Power Administration (Southwestern) has confirmed, approved, and placed into effect on an interim basis Rate Order No. SWPA-87 (Rate Order), which provides the following Integrated System rate schedules: Wholesale Rates for Hydro Peaking Power (P-23), Wholesale Rates for Non-Federal Service (NFS-23), and Wholesale Rates for Excess Energy (EE-23). These new rate schedules replace the existing power rates under Rate Schedules P-13B, NFTS-13A, and EE-13 which expire on September 30, 2025. Rate Schedules P-23, NFS- 23, and EE-23 increase the annual wholesale power rate for the Integrated System by 22.8 percent.
Learn More✈️Proposed Airworthiness Directive for GE Aviation Engine Compliance
The FAA proposes to supersede Airworthiness Directive (AD) 2024-06-02, which applies to all GE Aviation Czech s.r.o. (GEAC) Model M601D-11, M601E-11, M601E-11A, M601E-11AS, M601E-11S, and M601F engines. AD 2024-06-02 was prompted by a report of a crack on the centrifugal compressor case mount pad weld area caused by a non- conforming weld (lack of welding penetration). AD 2024-06-02 requires a one-time detailed visual inspection (DVI) of the compressor case pad welds for any crack, and replacement of the compressor case if necessary. Since the FAA issued AD 2024-06-02, the manufacturer determined that the compliance time for the DVI can be extended, and repetitive inspections of the centrifugal compressor case must be accomplished. This proposed AD would require performing repetitive DVIs of the compressor case pad welds for any crack, replacing the compressor case if necessary, and sending certain inspection results to the manufacturer, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More🛒Proposed Deletions from Procurement List
The Committee is proposing to delete product(s) and service(s) from the Procurement List that were furnished by nonprofit agencies employing persons who are blind or have other severe disabilities.
Learn More✈️FAA Airworthiness Directive for Boeing
The FAA is superseding Airworthiness Directive (AD) 2021-09- 06, which applied to all The Boeing Company Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes. AD 2021-09-06 required repetitive inspections for cracking of the left- and right-hand outboard chords of certain frame fittings and failsafe straps at a certain station around eight fasteners, and repair if any cracking is found. This AD was prompted by additional reports of cracking in the area and a subsequent determination that additional inspections are needed to address the unsafe condition. This AD requires repetitive detailed and ultrasonic inspections for cracking of the left- and right-hand sides of certain frame fittings and failsafe straps, and repair if any cracking is found. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More💰Proposed Fee Changes by OCC
The Options Clearing Corporation has filed a proposed rule change with the Securities and Exchange Commission to update its schedule of clearing fees. This includes an increase in the per contract clearing fee and the removal of a flat transaction fee, aimed at addressing anticipated cash flow needs based on various financial forecasts. The notice invites public comments regarding these changes.
Learn More🚁FAA Airworthiness Directive on Airbus Helicopters 2025-03-01
The FAA is superseding Airworthiness Directive (AD) 2021-04- 18, which applied to Airbus Helicopters Model EC225LP helicopters. AD 2021-04-18 required repetitively inspecting the bearing in the swashplate assembly of certain main rotor (M/R) mast assemblies and, depending on the findings, replacing the M/R mast assembly. AD 2021-04- 18 also prohibited installing those M/R mast assemblies unless certain requirements were met. Since the FAA issued AD 2021-04-18, it was determined that additional M/R mast assemblies are affected by the same unsafe condition and that it is necessary to distinguish the affected part numbers between M/R mast assemblies and mast swashplate assemblies. This AD continues to require the actions specified in AD 2021-04-18 and adds additional part-numbered M/R mast assemblies and distinguishes the affected part numbers between M/R mast assemblies and mast swashplate assemblies, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD also clarifies the possible consequences that could result from the unsafe condition and clarifies a requirement. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Issues Airworthiness Directive for Bombardier Airplanes
The FAA is superseding Airworthiness Directive (AD) 2021-10- 02, which applied to all Bombardier, Inc., Model BD-700-1A10 and BD- 700-1A11 airplanes. AD 2021-10-02 required repetitive general visual inspections of the left- and right-hand elevator torque tube bearings for any sand, dust, or corrosion; repetitive functional tests of the elevator control system; and replacement of the elevator torque tube bearings if necessary. This AD continues to require certain actions in AD 2021-10-02 and requires revising the existing maintenance or inspection program, as applicable, to incorporate a new airworthiness limitation. This AD was prompted by a determination that a new airworthiness limitation is necessary. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚫OFAC Sanctions Action Impacting Business Compliance – January 2025
The U.S. Department of the Treasury's Office of Foreign Assets Control (OFAC) is publishing the name of one entity that has been placed on OFAC's Specially Designated Nationals and Blocked Persons List (SDN List) based on OFAC's determination that one or more applicable legal criteria were satisfied. All property and interests in property subject to U.S. jurisdiction of this entity are blocked, and U.S. persons are generally prohibited from engaging in transactions with them.
Learn More💼Proposed PBGC Rule on Premium Rates and Reporting Changes
The Pension Benefit Guaranty Corporation (PBGC) proposes miscellaneous technical corrections, clarifications, and improvements to its regulations, including its regulations on premium rates, premium due dates, and termination of single-employer plans. These changes are a result of PBGC's ongoing retrospective review of the effectiveness and clarity of its rules and of statutory changes.
Learn More