✈️FAA Issues Airworthiness Directive for Bombardier Airplanes
The FAA is superseding Airworthiness Directive (AD) 2021-10- 02, which applied to all Bombardier, Inc., Model BD-700-1A10 and BD- 700-1A11 airplanes. AD 2021-10-02 required repetitive general visual inspections of the left- and right-hand elevator torque tube bearings for any sand, dust, or corrosion; repetitive functional tests of the elevator control system; and replacement of the elevator torque tube bearings if necessary. This AD continues to require certain actions in AD 2021-10-02 and requires revising the existing maintenance or inspection program, as applicable, to incorporate a new airworthiness limitation. This AD was prompted by a determination that a new airworthiness limitation is necessary. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Issues New Airworthiness Directive for Airbus SAS Airplanes
The FAA is superseding Airworthiness Directive (AD) 2022-16- 06, which applied to certain Airbus SAS Model A330-200, A330-200 Freighter, A330-300, and A330-900 series airplanes; and all Model A340- 200 and A340-300 series airplanes. AD 2022-16-06 required modifying the trimmable horizontal stabilizer actuator (THSA) installation, implementing the electrical load sensing device (ELSD) wiring provisions, and installing and activating the ELSD. This AD was prompted by tests that demonstrated that when the upper secondary load path (SLP) of the THSA is engaged, the THSA might not stall, with consequently no indication of SLP engagement, and by the recent determination that the required actions of AD 2022-16-06 cannot be accomplished on certain airplanes. This AD continues to require the actions in AD 2022-16-06 with revised procedures, and also requires additional actions for certain airplanes, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directive for CFM Engines by FAA
The FAA is adopting a new airworthiness directive (AD) for certain CFM International, S.A. (CFM) Model LEAP-1A and LEAP-1C engines. This AD was prompted by an investigation of an in-flight shut down event that revealed the aft arm of the high-pressure turbine (HPT) rotor interstage seal had failed. This AD requires removal from service and replacement of the HPT rotor interstage seal for LEAP-1A engines. Since the HPT rotor interstage seal part number is interchangeable between LEAP-1A and LEAP-1C engines, this AD also prohibits installation of these affected parts onto any LEAP-1A or LEAP-1C engine. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Airworthiness Directive for DAHER Model TBM 700 Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain DAHER AEROSPACE (DAHER) Model TBM 700 airplanes. This AD was prompted by reports of wear of the inner flap actuator drive nut. This AD requires cleaning and lubricating the internal actuator rods, measuring the play between the drive nuts and the internal actuator rods, and if any play is found, replacing the drive nuts. This AD also allows replacing the drive nuts with certain other design drive nuts as terminating action for the requirements. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Airworthiness Directive on Boeing 767
The FAA is superseding Airworthiness Directive (AD) 2019-14- 13, which applies to all The Boeing Company Model 767-200, -300, -300F, and -400ER series airplanes. AD 2019-14-13 required identifying the part number, and the serial number if applicable, of the Captain's and First Officer's seats, and performing applicable on-condition actions for affected seats. AD 2019-14-13 also required a one-time detailed inspection and repetitive checks of the horizontal movement system (HMS) of the Captain's and First Officer's seats, and applicable on- condition actions. AD 2019-14-13 also provided an optional terminating action for the repetitive actions for certain seats. This AD was prompted by reports of uncommanded fore and aft movement of the Captain's and First Officer's seats. This AD retains the actions in AD 2019-14-13 and adds an inspection of previously omitted part numbers. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚁FAA Issues Airworthiness Directive for Airbus Helicopters
The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Model AS332L, AS332L1, AS 365 N3, SA-365C1, SA- 365C2, SA-365N, and SA-365N1 helicopters. This AD was prompted by a report that certain rescue hoist cable assemblies may be equipped with a defective ball end. This AD requires inspecting certain rescue hoist cable assemblies and, depending on the results, replacing the rescue hoist cable assembly. This AD also allows installing certain rescue hoist cable assemblies and certain rescue hoists provided its requirements are met. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Airworthiness Directive for Boeing Aircraft
The FAA is adopting a new airworthiness directive (AD) for certain The Boeing Company Model 767-200, -300, and -400ER series airplanes. This AD was prompted by a report of multiple engine indicating and crew alerting system messages during potable water servicing after the water leaked onto the electronics equipment cooling air filter. This AD requires installation of hoseducts around the left-side section 43 potable water supply hoses and connections, a potable water system leakage test, and applicable corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Proposed AD for Boeing 757
The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 757-200, -200CB, and -300 series airplanes. This proposed AD was prompted by a report of cracking found in new locations at a certain body station (STA) during frame segment replacement repairs, including in the web at the K-hole between certain stringers, in the outer chord above the lower hinge intercostal, and in the inner chord and web between certain stringers. This proposed AD would require an inspection or records check for the presence of approved or local repairs, repetitive eddy current inspections for cracking, and applicable on-condition actions. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️FAA Issues Airworthiness Directive for Aircraft Buckle Compliance
The FAA is superseding Airworthiness Directive (AD) 2021-07-13 for certain Pacific Scientific Company rotary buckle assemblies (buckles). AD 2021-07-13 required inspecting each specified buckle including its buckle handle vane and prohibited installing affected buckles. This AD was prompted by the publication of an updated service bulletin, which revises the applicability based on date of manufacture of the affected buckles. This AD retains certain requirements of AD 2021-07-13, reduces the applicability, and requires performing corrective actions by complying with certain portions of the updated service bulletin. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Airworthiness Directive for Rolls-Royce Engines Effective 2025
The FAA is adopting a new airworthiness directive (AD) for certain Rolls-Royce Deutschland Ltd & Co KG (RRD) Model Trent XWB-97 engines. This AD was prompted by a report of damage to the main fuel hose assembly of the fuel manifold, which resulted an in-flight shut down. This AD requires a one-time set of visual and dimensional inspections of the main fuel hose assembly of the fuel manifold to confirm softness, compliance, and lack of resistance, and for shrinkage, cracks, chafing, dents, kinks, necking, and degradation of the hose braid wire; and, if necessary, replacement of the main fuel hose assembly of the fuel manifold, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More