🚁New Airworthiness Directive for Airbus Helicopters Effective May 2025
The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Model SA330J helicopters. This AD was prompted by the determination that new or more restrictive airworthiness limitations are necessary. This AD requires revising the existing maintenance records by incorporating new or more restrictive airworthiness limitations, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚁Airworthiness Directives for Airbus Helicopters
The FAA is adopting a new airworthiness directive (AD) for all Airbus Helicopters Model AS332C1 helicopters. This AD was prompted by a determination that new or more restrictive airworthiness limitations are necessary. This AD requires revising the airworthiness limitations section (ALS) of the existing maintenance manual (MM) or instructions for continued airworthiness (ICAs) and the existing approved maintenance or inspection program, as applicable, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Airworthiness Directive for Embraer EMB-505 Airlines
The FAA proposes to supersede Airworthiness Directive (AD) 2023-22-11, which applies to certain Embraer S.A. (Embraer) Model EMB- 505 airplanes. AD 2023-22-11 requires repetitively replacing the clutch retaining bolt and washer of the aileron autopilot servo mount. Since the FAA issued AD 2023-22-11, the FAA has determined that the applicability should be expanded to include all Model EMB-505 airplanes and, for certain airplanes, an additional requirement is necessary for the initial replacement of the retaining bolt and washer. This proposed AD would also provide an optional terminating action for the repetitive retaining bolt and washer replacement. These actions are specified in an Ag[ecirc]ncia Nacional de Avia[ccedil][atilde]o Civil (ANAC) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More🚁FAA Directive on Airbus Helicopters
The FAA is superseding Airworthiness Directive (AD) 2008-10-01 and AD 2010-05-51, which applied to certain Eurocopter France (now Airbus Helicopters) Model EC120B helicopters. AD 2008-10-01 required replacing certain part-numbered and serial-numbered spherical thrust bearings. AD 2010-05-51 required repetitively inspecting the main rotor (M/R) head rotor hub (rotor hub) and, depending on the results, taking corrective action. Since the FAA issued those ADs, the manufacturer revised the airworthiness limitations section (ALS) to incorporate various airworthiness limitations, tasks, and associated thresholds and intervals that were previously contained in service bulletins, as well as incorporate a new task. This AD requires revising the ALS of the existing maintenance manual (MM) or instructions for continued airworthiness (ICAs) and the existing approved maintenance or inspection program, as applicable, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Proposes Airworthiness Directive for Boeing 757-200 Inspections
The FAA proposes to supersede Airworthiness Directive (AD) 2018-26-03, which applies to all The Boeing Company Model 757-200 series airplanes. AD 2018-26-03 requires, for the Captain's and First Officer's seats, repetitive horizontal actuator identifications, repetitive checks of the horizontal movement system (HMS), a detailed inspection of the HMS, as applicable, and applicable on-condition actions. AD 2018-26-03 also requires a general visual inspection to determine the seat part numbers of the Captain's and First Officer's seats, a cable adjustment check on seats with certain seat part numbers, and applicable on-condition actions. Since the FAA issued AD 2018-26-03, the FAA has determined that additional seats are affected by the unsafe condition. This proposed AD would retain the actions required by AD 2018-26-03 and add an inspection for previously omitted part numbers. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️FAA Airworthiness Directive for Embraer Airplanes' Safety Compliance
The FAA is adopting a new airworthiness directive (AD) for all Embraer S.A. Model ERJ 190-300 and ERJ 190-400 airplanes. This AD was prompted by a report of a MAU 3B failure which led to brake fault advisory messages followed by loss of normal braking that was undetected until the brakes were pressed by the pilots. This AD requires revising the existing airplane flight manual (AFM) to incorporate procedures associated with the failure of certain modular avionics units (MAUs), as specified in an Ag[ecirc]ncia Nacional de Avia[ccedil][atilde]o Civil (ANAC) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Proposes Airworthiness Directive for Boeing 777 Models
The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 777-200LR Series and 777-300ER Series airplanes. This proposed AD was prompted by reports of chafing and arcing damage on the light emitting diode (LED) sidewall wire bundles. This proposed AD would require a general visual inspection (GVI) of the sidewall light for chafing damage and applicable on- condition actions. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Airworthiness Directive on Airbus SAS
The FAA proposes to supersede Airworthiness Directive (AD) 2016-14-03, which applies to all Airbus SAS Model A319-111, -112, -113, -114, -115, -131, -132, and -133 airplanes; Model A320-211, -212, -214, -231, -232, and -233 airplanes; and Model A321-111, -112, -131, -211, - 212, -213, -231, and -232 airplanes. AD 2016-14-03 requires reinforcing the forward pressure bulkhead at a certain stringer on both the left- hand and right-hand sides and doing related investigative and corrective actions if necessary. Since the FAA issued AD 2016-14-03, new crack findings have prompted the need for repetitive inspections of the area. This proposed AD would continue to require the actions in AD 2016-14-03, add repetitive inspections of structure at a certain frame and applicable corrective actions, provide a terminating action for the repetitive inspections, and remove airplanes from the applicability, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Airworthiness Directive for Airbus A350 Aircraft
The FAA proposes to adopt a new airworthiness directive (AD) for all Airbus SAS Model A350-941 and -1041 airplanes. This proposed AD was prompted by a determination that the applicable aircraft flight manual (AFM) was providing an incorrect value for maximum cumulative taxi time in freezing fog conditions. This proposed AD would require revising the existing AFM to provide the flightcrew with normal procedures to follow under certain conditions, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Airworthiness Directive for BAE Systems Airplanes
The FAA proposes to supersede Airworthiness Directive (AD) 2023-02-06, which applies to all BAE Systems (Operations) Limited Model 4101 airplanes. AD 2023-02-06 requires revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. Since the FAA issued AD 2023-02-06, the FAA has determined that new or more restrictive airworthiness limitations are necessary. This proposed AD would continue to require certain actions in AD 2023-02-06 and require revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive airworthiness limitations. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More