✈️Proposed Airworthiness Directive for International Aero Engines
The FAA proposes to adopt a new airworthiness directive (AD) for certain International Aero Engines AG (IAE AG) Model V2522-A5, V2524-A5, V2525-D5, V2527-A5, V2527E-A5, V2527M-A5, V2528-D5, V2530-A5, V2531-E5, and V2533-A5 engines. This proposed AD was prompted by a manufacturer investigation that revealed a quality escape following angled ultrasonic inspections (AUSIs) performed on certain high- pressure turbine (HPT) 1st-stage hubs and HPT 2nd-stage hubs. This proposed AD would require removal and replacement of certain HPT 1st- stage hubs and HPT 2nd-stage hubs. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️New FAA Airworthiness Directives Affecting Ipeco Pilot Seats
The FAA is adopting a new airworthiness directive (AD) for certain Ipeco Holdings Limited (Ipeco) pilot and co-pilot seats. This AD was prompted by reports of unexpected rearward movement of pilot and co-pilot seats during take-off and landing. This AD requires a one-time visual inspection of each affected seat, accomplishment of applicable corrective actions, and operational tests. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Airworthiness Directive for Bombardier BD-700 Aircraft
The FAA is adopting a new airworthiness directive (AD) for certain Bombardier Inc. Model BD-700-1A10 and BD-700-1A11 airplanes. This AD was prompted by a report that incorrect information was found in certain calculation tables in a section of the airplane flight manual (AFM) that addresses certain slat-flap conditions. This AD requires revising the Non-Normal Procedures section of the existing AFM to provide the flightcrew with corrected procedures to use in certain slat-flap conditions. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Final Rule on Airworthiness Directive for Airbus A350 Aircraft
The FAA is superseding Airworthiness Directive (AD) 2020-03- 14, which applied to all Airbus SAS Model A350-941 and -1041 airplanes. AD 2020-03-14 required an inspection of affected crew oxygen cylinder assemblies for any discrepancy and replacement of discrepant crew oxygen cylinder assemblies with serviceable parts, and allowed installation of affected parts under certain conditions. Since the FAA issued AD 2020-03-14, the supplier introduced an improved crew oxygen cylinder assembly, that will ensure the correct function of the system. This AD continues to require the actions in AD 2020-03-14, requires replacement of all affected parts with redesigned parts, and also prohibits the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directives for MHI RJ Aviation Airplanes
The FAA is adopting a new airworthiness directive (AD) for all MHI RJ Aviation ULC Model CL-600-2C10 (Regional Jet Series 700, 701, and 702), CL-600-2C11 (Regional Jet Series 550), CL-600-2D15 (Regional Jet Series 705), CL-600-2D24 (Regional Jet Series 900), and CL-600-2E25 (Regional Jet Series 1000) airplanes. This AD was prompted by a determination that new or more restrictive aircraft maintenance manual (AMM) tasks are necessary. This AD requires revising the existing maintenance or inspection program, as applicable, to incorporate new or more restrictive AMM tasks, as specified in a Transport Canada, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Analysis of Pratt & Whitney Airworthiness Directive Compliance
The FAA proposes to adopt a new airworthiness directive (AD) for certain Pratt & Whitney Division (PW) Model PW4074, PW4074D, PW4077, PW4077D, PW4084D, PW4090, and PW4090-3 engines. This proposed AD was prompted by an analysis of an event involving an International Aero Engines, LLC (IAE LLC) Model PW1127GA-JM engine, which experienced a high-pressure compressor (HPC) 7th-stage integrally bladed rotor (IBR-7) separation that resulted in an aborted takeoff. This proposed AD would require repetitive angle ultrasonic scan inspections (AUSIs) of the HPC 15th-stage disks, front turbine hubs, high pressure turbine (HPT) 1st-stage air seals, and HPT 2nd-stage hubs for crack indications, and removal from service and replacement if necessary, and for certain serial numbers, removal from service and replacement of the HPT 1st-stage air seal. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️FAA Airworthiness Directive Update for Boeing 787 Series Aircraft
The FAA is correcting an airworthiness directive (AD) that was published in the Federal Register. The AD applies to certain The Boeing Company Model 787-9 and 787-10 airplanes. As published, a reference to the Alternative Methods of Compliance (AMOCs) paragraph in the regulatory text is incorrect. This document corrects that error. In all other respects, the original document remains the same.
Learn More🚁New Airworthiness Directive for Airbus Helicopters Requires Inspections
The FAA is adopting a new airworthiness directive (AD) for certain Airbus Helicopters Model AS350B2, AS350B3, and EC130B4 helicopters. This AD was prompted by reports of broken cargo swing frames and the determination to change an existing repetitive inspection threshold. This AD requires repetitively inspecting the cargo swing installation and frame and, depending on the results, performing corrective action, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚁FAA Issues Airworthiness Directive for Robinson Helicopter Inspections
The FAA is superseding Airworthiness Directive (AD) 2024-19-11 for all Robinson Helicopter Company Model R44 and R44 II helicopters. AD 2024-19-11 required visually inspecting a certain flex plate assembly (flex plate) and certain clutch shaft forward yokes (yokes), including each flex plate bolt, and depending on the results, taking corrective actions. AD 2024-19-11 also required removing certain yokes from service within a specified threshold, or as an alternative, performing in-depth inspections. Since the FAA issued AD 2024-19-11, it has been determined that clarifications regarding the alternative inspections are necessary. This AD requires the actions of AD 2024-19- 11 and clarifies that the alternative inspections are repetitive and adds a particular paint remover option to use when performing those alternative inspections. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️New Airworthiness Directive for Israel Aircraft Industries Airplanes
The FAA is adopting a new airworthiness directive (AD) for all Israel Aircraft Industries Ltd. Model 1124 and 1124A airplanes. This AD was prompted by the need to ensure proper thrust reverser system status and function and to minimize the possibility of thrust reverser operation in flight or before landing. This AD requires revising the limitations and normal procedures sections of the existing airplane flight manual (AFM). The FAA is issuing this AD to address the unsafe condition on these products.
Learn More