✈️FAA Proposes New Airworthiness Directive Affecting Airbus Aircraft
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus SAS Model A319-111, -112, -113, -114, -115, -131, - 132, -133 airplanes. This proposed AD was prompted by a widespread fatigue damage (WFD) scenario review for a certification project that indicated several cracks found around the potable water and wastewater service panels were WFD instead of typical fatigue. This proposed AD would require modification of the potable water and wastewater service panels, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️Proposed FAA AD Impacts Costs for GE Engine Compliance
The FAA is revising a notice of proposed rulemaking (NPRM) that applied to all General Electric Company (GE) Model CF34-10E2A1, CF34-10E6, CF34-10E6A1, CF34-10E7, and CF34-10E7-B engines with certain part-numbered high-pressure turbine (HPT) shroud/low pressure turbine (LPT) nozzle assemblies installed. This action revises the NPRM by adding Model CF34-10E5 and CF34-10E5A1 engines to the applicability. The FAA is proposing this airworthiness directive (AD) to address the unsafe condition on these products. Since these actions would impose an additional burden over those in the NPRM the agency is requesting comments on this SNPRM.
Learn More✈️FAA Proposes Airworthiness Directive for Airbus A321 Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for all Airbus SAS Model A321-251NX, -252NX, -253NX, -271NX, and -272NX airplanes. This proposed AD was prompted by discovery of two bushes that had migrated on the latch shaft of an emergency overwing exit door (OWED) during accomplishment of an inspection on an in-service airplane. This proposed AD would require repetitive detailed inspections (DETs) of the affected parts and, in case of discrepancies, modification of the affected parts, and would prohibit the installation of affected parts, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️FAA Proposes New Airworthiness Directive for Airbus Helicopters
The FAA proposes to adopt a new airworthiness directive (AD) for all Airbus Helicopters Model SA341G and SA342J helicopters. This proposed AD was prompted by reports of corrosion on the contact surfaces of the tail rotor inclined and horizontal drive shaft flanges. This proposed AD would require repetitively inspecting the inclined and horizontal drive shaft flanges and, depending on the results, replacing the inclined or horizontal drive shaft. This proposed AD would also prohibit installing certain inclined and horizontal drive shafts unless certain requirements are met, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️Proposed FAA Airworthiness Directive for Boeing 737 Video Monitors
The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 737-600, -700, -700C, -800, -900, and 900ER series airplanes. This proposed AD was prompted by a report that some passenger service unit (PSU)-mounted video monitors became detached from the PSU rails during a hard landing. This proposed AD would require replacing PSU-mounted video monitors that do not have secondary retention lanyards. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More🚁Proposed FAA Airworthiness Directive for Airbus Helicopters
The FAA proposes to adopt a new airworthiness directive (AD) for Airbus Helicopters Model AS350B, AS350BA, AS350B1, AS350B2, AS350B3, AS350D, AS355E, AS355F, AS355F1, AS355F2, AS355N, and AS355NP helicopters. This proposed AD was prompted by a report of a sliding door that was locked in the open position detaching from the helicopter during flight. This proposed AD would require modifying certain upper rail rollers, installing a label on each sliding door, and prohibit installing affected upper rail rollers or a door having an affected upper rail roller. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️Proposed AD for Boeing 757 Video Monitor Compliance Costs
The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 757-200 and -300 series airplanes. This proposed AD was prompted by a report that some passenger service unit (PSU)-mounted video monitors became detached from the PSU rails during a hard landing. This proposed AD would require replacing PSU- mounted video monitors that do not have secondary retention lanyards. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️NPRM for Boeing Airworthiness Directive
The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 787-8, 787-9, and 787-10 airplanes. This proposed AD was prompted by reports of multiple supplier notices of escapement (NOEs) indicating that seat track splice fittings were possibly manufactured with an incorrect titanium alloy material. This proposed AD would require an inspection of seat track splice fittings to determine the material and applicable on-condition actions. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️FAA Airworthiness Directive for Embraer ERJ 190-300 Air
The FAA is superseding Airworthiness Directive (AD) 2023-23- 10, which applied to all Embraer S.A. Model ERJ 190-300 airplanes. AD 2023-23-10 required repetitive inspections of the press-fitted bushings of the wing ailerons for migration and broken sealant, measurements of the distance between the aileron surfaces and hinge fittings, functional checks of the backlash of the wing aileron control system, and all applicable related investigative and corrective actions. Since the FAA issued AD 2023-23-10, it was determined that certain requirements needed to be clarified. This AD continues to require all actions of ANAC AD 2023-06-01 with revised compliance requirements, as specified in an Ag[ecirc]ncia Nacional de Avia[ccedil][atilde]o Civil (ANAC) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚁Proposed FAA Airworthiness Directive for Siam Hiller Helicopters
The FAA proposes to adopt a new airworthiness directive (AD) for Siam Hiller Holdings, Inc. (Siam Hiller), Model UH-12E (Army OH-23G and H-23F) and UH-12E-L helicopters. This proposed AD was prompted by reports of cracks found in a main rotor (M/R) transmission drive shaft (drive shaft). This proposed AD would require inspecting certain M/R drive shafts for a crack, prohibit installing certain M/R drive shafts unless the inspection is done, and prohibit using certain paint removers. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More