✈️FAA Airworthiness Directive for Airbus Model Airplanes Compliance
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A318, A319, A320, and A321 series airplanes. This AD was prompted by a heavy maintenance check that found elongation on the upper section of the vertical member's assembly at the frame (FR) 24A cargo panel sub-structure. This AD requires a check for certain repairs, and as applicable, repetitive detailed visual inspections of the vertical member's upper part and the upper fittings at FR 24A in the forward cargo compartment and corrective actions. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️FAA Airworthiness Directive for Airbus Aircraft Compliance Guidelines
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A319-151N, -153N, -171N, and -173N airplanes; Model A320-251N, -252N, -253N, -271N, -272N, and -273N airplanes; and Model A321-251N, -252N, -253N, -271N, -272N, -251NX, -252NX, -253NX, -271NX, -272NX, -253NY, and -271NY airplanes. This AD was prompted by occurrences of high-pressure bleed valve (HPV) butterfly seal retention clip rupture. This AD requires revising the existing airplane flight manual (AFM) and the existing FAA-approved minimum equipment list (MEL), allows replacement of each affected HPV as an optional terminating action, and prohibits the installation of affected parts. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Airworthiness Directives for Airbus A321 Models
The FAA proposes to supersede Airworthiness Directive (AD) 2017-14-14, which applies to all Airbus SAS Model A321-111, -112, -131, -211, -212, -213, -231, and -232 airplanes. AD 2017-14-14 requires repetitive inspections for cracking in the cabin floor beam junction at certain fuselage frame locations, and repair if necessary. Since the FAA issued AD 2017-14-14, further analysis determined that the compliance times for the inspections must also be based on flight hours. This proposed AD would continue to require the actions in AD 2017-14-14, and would require revised compliance times and add a provision for optional modifications, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference (IBR). The FAA is proposing this AD to address the unsafe condition on these products.
Learn More