🚁New FAA Airworthiness Directive for Airbus Helicopters Model H160-B
The FAA is superseding Airworthiness Directive (AD) 2024-26- 01, which applied to all Airbus Helicopters Model H160-B helicopters. AD 2024-26-01 required measuring the axial play of the rotating scissors spherical bearings, and depending on the results, accomplishing corrective action and reporting inspection results. Since the FAA issued AD 2024-26-01, Airbus Helicopters issued revised material to extend the applicability to all rotating scissors spherical bearing serial numbers, change the initial compliance time, establish repetitive inspections, and extend the reporting requirements. This AD was prompted by a determination that the initial compliance time and reporting requirement needed to be modified and repetitive inspections for certain axial play measurements added. This AD retains the actions required in AD 2024-26-01, revises the initial compliance time, extends the definition of an affected part to all serial numbered rotating scissors spherical bearings, extends the reporting requirements, and requires repetitive inspections. This AD also prohibits installing an affected rotating scissors spherical bearing unless certain requirements are met. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Airworthiness Directive for Airbus Helicopters
The FAA proposes to adopt a new airworthiness directive (AD) for all Airbus Helicopters Model SA341G and SA342J helicopters. This proposed AD was prompted by reports of disbonding of the stainless steel leading edge protection of certain part-numbered main rotor blades (MRB). This proposed AD would require repetitively tap inspecting the MRB and, depending on the results, repairing or replacing the MRB. This proposed AD would also prohibit installing those MRB unless certain requirements are met. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More🚁FAA Airworthiness Directive for Airbus Helicopters Compliance
The FAA is adopting a new airworthiness directive (AD) for certain Airbus Helicopters Model AS332L1 and EC225LP helicopters. This AD was prompted by a determination of a possible interference of the hoist operator's helmet cord with the toggle switch of the hoist cable cut control. This AD requires replacing, or modifying and re- identifying, certain hoist shear toggle switch supports, and prohibits installing certain hoist shear toggle switch supports, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🚁FAA Directive on Airbus Helicopters
The FAA is superseding Airworthiness Directive (AD) 2008-10-01 and AD 2010-05-51, which applied to certain Eurocopter France (now Airbus Helicopters) Model EC120B helicopters. AD 2008-10-01 required replacing certain part-numbered and serial-numbered spherical thrust bearings. AD 2010-05-51 required repetitively inspecting the main rotor (M/R) head rotor hub (rotor hub) and, depending on the results, taking corrective action. Since the FAA issued those ADs, the manufacturer revised the airworthiness limitations section (ALS) to incorporate various airworthiness limitations, tasks, and associated thresholds and intervals that were previously contained in service bulletins, as well as incorporate a new task. This AD requires revising the ALS of the existing maintenance manual (MM) or instructions for continued airworthiness (ICAs) and the existing approved maintenance or inspection program, as applicable, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More🛩️New Airworthiness Directive for Airbus AS332C Helicopters Proposed
The FAA proposes to adopt a new airworthiness directive (AD) for all Airbus Helicopters Model AS332C helicopters. This proposed AD was prompted by a determination that new or more restrictive airworthiness limitations are necessary. This proposed AD would require revising the airworthiness limitations section (ALS) of the existing maintenance manual (MM) or instructions for continued airworthiness (ICAs) and the existing approved maintenance or inspection program, as applicable, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Rulemaking for Airbus EC225LP Airworthiness Directive
The FAA proposes to adopt a new airworthiness directive (AD) for all Airbus Helicopters Model EC225LP helicopters. This proposed AD was prompted by a determination that new or more restrictive airworthiness limitations are necessary. This proposed AD would require revising the airworthiness limitations section (ALS) of the existing maintenance manual (MM) or instructions for continued airworthiness (ICAs) and the existing approved maintenance or inspection program, as applicable, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More🚁Proposed Airworthiness Directive for Airbus Helicopters AS332L1
The FAA proposes to adopt a new airworthiness directive (AD) for all Airbus Helicopters Model AS332L1 helicopters. This proposed AD was prompted by a determination that new or more restrictive airworthiness limitations are necessary. This proposed AD would require revising the airworthiness limitations section (ALS) of the existing maintenance manual (MM) or instructions for continued airworthiness (ICAs) and the existing approved maintenance or inspection program, as applicable, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More🚁Proposed Airworthiness Directive for Airbus Helicopters MBB-BK 117
The FAA proposes to adopt a new airworthiness directive (AD) for all Airbus Helicopters Deutschland GmbH Model MBB-BK 117 C-2 and MBB-BK 117 D-2 helicopters. This proposed AD was prompted by reports of significant wear of the control rod assembly and pitch link assembly spherical bearings. This proposed AD would require measuring the radial play of certain control rod assembly and pitch link assembly spherical bearings, reporting the results, and depending on the results, taking corrective action. These actions are specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. This proposed AD would also prohibit installing certain control rod assemblies and pitch link assemblies unless certain requirements are met. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More🚁New Airworthiness Directive for Airbus Helicopters Compliance
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus Helicopters Model AS350B2, AS350B3, and EC130B4 helicopters. This proposed AD was prompted by reports of broken cargo swing frames and the determination to change an existing repetitive inspection threshold. This proposed AD would require repetitively inspecting the cargo swing installation and frame and, depending on the results, corrective action, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More🚁Proposed Airworthiness Directive for Leonardo Helicopters by FAA
The FAA proposes to adopt a new airworthiness directive (AD) for certain Leonardo S.p.a. Model A109E, A109S, and AW109SP helicopters. This proposed AD was prompted by reports of incorrect installation of the motor (MTR) cables and the bonding braids connected to the engine fire extinguisher bottles. This proposed AD would require inspecting the cables and bonding braids installation and, depending on the results, accomplishing corrective action, as specified in a European Union Aviation Safety Agency (EASA) AD, which is proposed for incorporation by reference. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More