✈️FAA Airworthiness Directive for CFM International Engines Compliance
The FAA is superseding Airworthiness Directive (AD) 2023-09- 06, which applied to all CFM International, S.A. Model (CFM) LEAP-1A23, LEAP-1A24, LEAP-1A24E1, LEAP-1A26, LEAP-1A26CJ, LEAP-1A26E1, LEAP-1A29, LEAP-1A29CJ, LEAP-1A30, LEAP-1A32, LEAP-1A33, LEAP-1A33B2, and LEAP- 1A35A (LEAP-1A) engines. AD 2023-09-06 required replacement of certain high-pressure turbine (HPT) rotor stage 1 disks (HPT stage 1 disks), forward outer seals, and compressor rotor stages 6-10 spools. AD 2023- 09-06 also prohibited installation of an HPT stage 1 disk, forward outer seal, or compressor rotor stages 6-10 spool that has a part number and serial number identified in the service information onto any engine. Since the FAA issued AD 2023-09-06, the manufacturer identified additional affected parts that were manufactured from material suspected to have reduced material properties due to iron inclusion, which prompted this AD. This AD retains the requirements to replace certain HPT stage 1 disks, forward outer seals, and compressor rotor stages 6-10 spools and expands the applicability to include additional affected parts manufactured from the same material suspected to have reduced material properties due to iron inclusion. The FAA is issuing this AD to address the unsafe condition on these products.
Learn More✈️Proposed Airworthiness Directive for International Aero Engines
The FAA proposes to adopt a new airworthiness directive (AD) for certain International Aero Engines AG (IAE AG) Model V2522-A5, V2524-A5, V2525-D5, V2527-A5, V2527E-A5, V2527M-A5, V2528-D5, V2530-A5, V2531-E5, and V2533-A5 engines. This proposed AD was prompted by a manufacturer investigation that revealed a quality escape following angled ultrasonic inspections (AUSIs) performed on certain high- pressure turbine (HPT) 1st-stage hubs and HPT 2nd-stage hubs. This proposed AD would require removal and replacement of certain HPT 1st- stage hubs and HPT 2nd-stage hubs. The FAA is proposing this AD to address the unsafe condition on these products.
Learn More