✈️FAA Airworthiness Directive for CFM International Engines Compliance
Airworthiness Directives; CFM International, S.A. Engines
Summary
The FAA is superseding Airworthiness Directive (AD) 2023-09- 06, which applied to all CFM International, S.A. Model (CFM) LEAP-1A23, LEAP-1A24, LEAP-1A24E1, LEAP-1A26, LEAP-1A26CJ, LEAP-1A26E1, LEAP-1A29, LEAP-1A29CJ, LEAP-1A30, LEAP-1A32, LEAP-1A33, LEAP-1A33B2, and LEAP- 1A35A (LEAP-1A) engines. AD 2023-09-06 required replacement of certain high-pressure turbine (HPT) rotor stage 1 disks (HPT stage 1 disks), forward outer seals, and compressor rotor stages 6-10 spools. AD 2023- 09-06 also prohibited installation of an HPT stage 1 disk, forward outer seal, or compressor rotor stages 6-10 spool that has a part number and serial number identified in the service information onto any engine. Since the FAA issued AD 2023-09-06, the manufacturer identified additional affected parts that were manufactured from material suspected to have reduced material properties due to iron inclusion, which prompted this AD. This AD retains the requirements to replace certain HPT stage 1 disks, forward outer seals, and compressor rotor stages 6-10 spools and expands the applicability to include additional affected parts manufactured from the same material suspected to have reduced material properties due to iron inclusion. The FAA is issuing this AD to address the unsafe condition on these products.
Agencies
- Transportation Department
- Federal Aviation Administration
Business Impact
$$$ - High
The regulation imposes requirements for CFM International engine compliance, mandating the replacement of specific parts to maintain airworthiness. This creates a financial burden for operators needing to comply with the directive, which has been quantified in the estimated costs section of the document.